Press Systems

Copper and Stainless-Steel press fitting systems — no brazing, no welding, no flame.

Lightning Copper Press

Lightning Copper Press

  • A smarter, safer, lead-free solution for copper tube installations across Water and Gas.
  • No brazing, soldering or flaring — fast, clean and secure connections using a pressing tool for consistent results.
  • Dual indicator mechanism helps reduce installation errors, and a unique Leak Path Design O-ring highlights any unpressed joints during pressure testing.
  • Coverage DN15 to DN50 with an extensive fitting range; noticeable cost savings from your first project.
View Copper Press Brochure

Lightning Stainless-Steel Press

  • 316 stainless-steel, lead-free press solution for stainless tube installations in Water and Gas.
  • No welding — fast, clean, secure connections with press tooling, dual indicator mechanism and Leak Path Design O-ring for unpressed-joint detection.
  • Coverage DN15 to DN168 with a broad fitting range; engineered for immediate install efficiency and cost savings.
View Stainless-Steel Press Brochure
Lightning Stainless-Steel Press

Approvals & Certifications

Standards and licence numbers for Lightning products, as stated in the Lightning technical documents. Download the Technical Guide for Architects or the Press System brochures for the full approvals.

Lightning product standards and certification licence numbers
ProductStandardApprovalNotes
Copper Press water fittings (DN15–DN50)AS 3688Watermark licence WMK27087DZR lead-free CW511L brass with EPDM sealing element. Install to AS/NZS 3500.
Copper Press gas fittings (DN15–DN50)AS 3688, tested to AS 3688 and BS 8537Licence SMK41743Copper and DZR lead-free CW511L brass with HNBR sealing element. Install to AS/NZS 5601, consumer piping pressure up to 200 kPa.
Stainless Steel Press tube (DN15–DN168)AS 5200.053, ASTM A269Watermark approval WM75213Outside diameters 15 mm to 168 mm.
Stainless Steel Press fittingsAS 3688Watermark approval WM75213, AMI GAS approval AMI75213316L stainless steel (EN 1.4404).

Pressure Testing Requirements

All Lightning press installations must be pressure tested in accordance with the relevant Australian Standards and any additional local regulations.

  • ✓Gas installations: test in accordance with AS/NZS 5601 – Appendix E
  • ✓Water installations: test in accordance with AS/NZS 3500
  • ✓Visually inspect all joints during testing

The Lightning press systems incorporate a Leak Path Design O-ring, which assists in identifying unpressed joints during pressure testing when installed and tested correctly.

View Full Technical Information

Explore the Full Product Range

PEX Systems, Press Systems, Tooling and more — engineered for Australian trades.